65-70 GM B Body 3″ To 10″ Car Lift Kit For Caprice, Impala & More

12 reviews
4.83 out of 5

From: $1,095.00


3″ to 10″ complete suspension kit for 1965-1970 Caprice, Impala, Belair, Biscayne, Executive, Kingswood, Townsman, and Brookwood. This kit installs under your factory coil springs to lift your Car 3 to 10 inches! Clear 22 inch up to 28 inch rims and tires with this kit (measure to be sure).


Looking for a complete suspension lift kit? Look no further

Comes with lift spacer cups, front and rear control arms, track bar, extended lift shocks, installation manual and full install DVD. This kit includes adjustable control arms for the front of the car to eliminate the negative camber (where the wheel tilts inwards towards the top) that is caused when lifting a car. Also included are the rear adjustable trailing arms to keep the wheel centered in the wheel well and drive shaft angle correct. The pan hard bar will keep your axle centered side to side. Adjustable arms will keep your tires from wearing excessively on the inside and will keep your alignment on straight.


Universal Car Lifts builds the best suspension parts for your ride

UCL parts are built out of rugged over-sized steel of the highest quality and craftsmanship. Parts have a durable black powder coat finish and lifetime warranty. 10″ Kit also includes universal body lift kit. Remember to add the Bushings and Ball joints! Most shops and customers agree that the installation time and stress levels are greatly reduced when you have us INSTALL the Bushings and Ball joints. Simply select the option that says “Installed In Kit”.


A special note about this kit

Special note: This kit comes standard with 1 rear upper trailing arm- your car may have 1 or 2 arms depending on engine size, year built, etc. Be sure to select the option for an additional arm if needed.



  • “Not Included” = You will need to get your own bushings and ball joints from a part store.
  • “Included In Kit” = The Kit will come with the bushings and ball joints (no cross shafts). You will need to install the bushings and ball joints.
  • “Installed In Kit” = The kit will come with the cross shafts and all the bushings and balljoints INSTALLED!! Customers agree this is the best option.